AES E-Loop Commercial loop kit EXIT MODE with LCD Transceiver - ELOOC-KLT

This commercial e-loop is the newest safety device from AES that acts as a safety loop but does not require digging or removing pavers. Use this exit mode e-loop before an exit. The kit version has an e-Trans 200 Transceiver, two concrete fixing bolts, and one magnet.
Part Number: ELOOC-KLT

$522.48 each


AES E-Loop Commercial loop kit EXIT MODE with LCD Transceiver - ELOOC-KLT

With no digging required, the e-loop (exit mode) is a Commercial Wireless Vehicle Detection System that uses the technology of magnetometer sensors to sense when vehicles move or are near the e-loop. When the e-loop detects a vehicle, this information is transmitted to a transceiver to activate the gate. This kit includes an e-Trans 200 LCD Transceiver, two concrete fixing bolts, and a magnet. Install these sensors on the surface of an exit passage. Four replaceable Lithium batteries come with the system. The e-loop is strong enough to withstand almost any vehicle weight. This is an exit-only commercial e-loop.

Kit Includes:

  • E-Trans 200 Transceiver
  • 2 Concrete Fixing Bolts
  • 1 Magnet

Key Features:

  • Easy Installation
  • 10-Year Battery Life
  • Reliable Radio Communications With Transceivers
  • High Security 128-Bit AES Encryption
  • Exit Detection Mode
  • 8 Hz Sampling Rate
  • Auto Calibration
  • IP68 Ingress Protection


  • Frequency: 433.39 MHz
  • Modulation: FSK
  • Bitrate: 9.6 KBPS
  • Bandwidth: 250 kHz
  • Antenna Type: PCB
  • Nominal Output Power: 10 dBm
  • Receive Sensitivity: -126.2 dBm
  • Security: 128-Bit AES Encryption
  • Power: 4 * 3.6 V 2700ma
  • Operating Temp: -4°F To 176°F
Product E-Loop Kit
Loop Type Magnetometer Detection
Product Type Wireless Loops
Installation Method Surface Mount
Manufacturer AES Global, LLC