AES E-Loop Commercial Radar Loop Only With PRESENCE MODE - EL00C-RAD

The Commercial Radar E-Loop with presence mode only is an e-loop that uses magnetometer sensors and radar to ensure transmission is sent to the gate to either open or close. It is one of the safest ways to ensure any accidents do not happen near your gate.
Part Number: EL00C-RAD

$392.00 each


AES E-Loop Commercial Radar Loop Only With PRESENCE MODE - EL00C-RAD

The Commercial Radar Loop uses the latest technology to detect vehicles without digging or wiring. The wireless vehicle detection system can sense the presence of upcoming vehicles and submit this transmission to a transceiver for gate activation. Once the vehicle is detected, the e-loop will then switch to radar mode. These sensors can be installed on either the surface of an exit or entryway. The radar loop comes with four replaceable Lithium batteries. The radar sensor works to detect vehicles that are stopped on top of the e-loop. Using radar and magnetometer sensors, the vehicle radar loop can sense a vehicle even if the magnetic field drops. Change radar settings with the e-diagnostics remote.

Key Features:

  • Easy Installation
  • Set Radar Settings Including Dead Zones, Sensitivity, And Magnetic Field Release Levels
  • 6-Year Battery Life
  • Reliable Radio Communications With Transceivers
  • High Security 128-Bit AES Encryption
  • Presence Mode Detection
  • 8 Hz Sampling Rate
  • Auto Calibration
  • IP68 Ingress Protection


  • Frequency: 433.39 MHz
  • Modulation: FSK
  • Bitrate: 9.6 KBPS
  • Bandwidth: 250 kHz
  • Antenna Type: PCB
  • Nominal Output Power: 10 dBm
  • Receive Sensitivity: -126.2 dBm
  • Security: 128-Bit AES Encryption
  • Power: 4 * 3.6 V 2700ma
  • Operating Temp: -4°F To 176°F
Product E-Loop
Loop Type Magnetometer/Radar Detection
Product Type Wireless Loops
Installation Method Surface Mount
Manufacturer AES Global, LLC