Miller Edge OptiGuard Monitored Thru-Beam Photo Eye With Mounting Bracket and Hood

The OptiGuard is a through-beam, monitored photo eye for automatic gate and door applications. This photoelectric sensor is UL325 compliant and comes with a receiver, emitter, and mounting hood and brackets.
Part Number: OG-T-K10
$119.80 each
$119.80 each
OR
 

Details

Miller Edge OptiGuard Monitored Thru-Beam Photo Eye With Mounting Bracket and Hood

The Miller Edge OptiGuard is a monitored photo eye system that provides thru-beam entrapment protection for vehicles and pedestrians. This photo eye sensor is designed to be used with automatic door openers and gate operator systems. If an obstruction breaks the photo eye system's beam, a signal is sent to the door or gate opener, causing the motor to stop and reverse motion.

The OptiGuard photoelectric sensor comes with an emitter and receiver, both of which can be installed and mounted vertically or horizontally to meet security conditions. This through-beam photo eye for gate openers has a range of up to 100 ft. The durable mounting bracket also acts as a hood and provides extra protection against severe weather, debris, and the sun. The OptiGuard is easy to install and aligns with a visible light beam. It is a UL 325 recognized entrapment protection device with a limited 2-year warranty.

OptiGuard Includes

  • 1 Emitter
  • 1 Receiver
  • 2 Mounting Brackets/Hoods

Features

  • 100' Range
  • Options To Mount Vertically or Horizontally
  • Mounting Bracket & Hood For Debris/Weather Protection
  • IP67 Housing For Protection Against Moisture & Dust
  • UL 325 Recognized Type B1 Component
  • 2 Year Warranty

Specifications

  • Operating Range: 6' - 100'
  • Cable Length: 6'
  • Operating Temperature: -13 degrees F (-25 degrees C) to (+55 degrees C) +131 degrees F
  • Power Source: 12-40 volts DC, 24-48 volts AC
  • Mounting Orientation: Horizontal, Vertical
  • Emitter Material: Polycarbonate
  • Emitter Dimensions: 0.75" W x 2.5" H x 1.38" D (19 x 64 x 35 mm)
  • Receiver Material: Polycarbonate
  • Receiver Dimensions: 0.75" W x 2.5" H x 1.38" D (19 x 64 x 35 mm)
  • Mounting Hood Material: Galvanized Steel
  • Mounting Hood Dimensions: 1.75" W x 4" H x 2.38" D (44 x 102 x 60 mm)

Optiguard Photo Eye Installation

  1. Mount the emitter and the receiver in the preferred orientation, (vertically or horizontally), in their desired locations. Leave hardware slightly loosened.
  2. Power the emitter and receiver by connecting them to the operator per the wiring diagram. Disconnect power to the operator before wiring for safety.
  3. Align the receiver with the emitter by turning them left or right until the yellow receiver LED turns solid. Tighten the mounting screws.
Prefer to Call? (888) 378-1043

Questions about part number OG-T-K10?

Required Fields *

Name *

Email *

Phone

My Questions *

SKU OG-T-K10
Product Photo Eye
Monitored/Non-Monitored Monitored
Input Voltage 12 DC, 24 DC, 24 AC, 36 DC, 36 AC, 48 AC
Photo Eye Type Through-Beam
Voltage 12-40 DC or 24-48 AC
Monitored Type Normally Closed (NC)
Product Type Photo Eyes
Manufacturer Miller Edge, Inc.
Specification Sheet Download PDF file
Installation Guide Download PDF file